Solutions: The easiest (and most obvious) way to address underwatering is to fully hydrate the plant. However, this must be done carefully. A common mistake that many gardeners make is to douse their underwatered plants with water. This can overwhelm the roots of the plant and shock its system, something that can be even more damaging than the lack of water to begin with. Instead, water thoroughly and slowly, taking breaks to let the water slowly saturate through the soil to get to the roots. Use room temperature water, as cold water might be too much of a shock. In the future, shorten the time between waterings. A good rule of thumb is to check the soil around each plant daily. If it’s dry to at least two inches down, it’s time to water. If a container plant is repeatedly drying out very quickly, repotting into a slower-draining container might be a good idea, too.

Solutions: Bacterial infections need to be treated quickly to prevent the spread to neighboring, healthy plants, potentially wiping out large sections of your indoor or outdoor garden. In mild cases: Use sterilized (10% bleach solution) pruning shears or scissors to remove any infected plant parts, making sure to dispose of them off site. Use a copper-based bactericide to treat the unaffected foliage, as well as the soil, and neighboring plants. Follow the manufacturer’s rate and timing directions found on the product label. In severe cases, where more than half the leaves are affected: Remove all of the infected plants from the garden, disposing of them off site. Treat the soil and neighboring plants using a copper-based bactericide. Follow the manufacturer’s rate and timing directions found on the product label.

Solutions: As powdery Mildew spores are transported by the wind, it can be tricky to put a complete stop to the spread of the fungus. Luckily, there are several easy treatments for plants that are exhibiting symptoms: If powdery Mildew seems to be impacting isolated leaves or stems, they can simply be trimmed away and disposed of. Disinfect pruning tools after doing this. Remove any plant debris from the ground around the infected plants and dispose of it in the garbage. Then, cover the soil with a thick layer of mulch to limit reinfection. Milk sprays have been found to be useful in controlling powdery Mildew. Make up a spray consisting of 60% water and 40% milk and spray on the affected plants. This can also be used as a preventative measure. In cases where powdery Mildew is more widespread, plants can be sprayed with a mild sulfur- or copper-based fungicide or a non-toxic solution made from baking soda and soap. Sprays can help areas that have been recently infected, though they are less effective against well-established infections. If possible, try transplanting the plants to a sunnier location. Though powdery Mildew does fine in hot, dry conditions, it is unable to reproduce without some humidity. Putting plants in more direct sunlight can help stop the spread of the fungus. Trimming around closely-packed plants can help improve airflow, which also prevents the reproduction of the fungus.

Solutions: Your plant is very thirsty and needs water promptly. You can revive your plant by giving it water. The easiest technique is to slowly pour water into your plant’s soil so that the whole surface is moistened. If you pour the water too quickly, the water will flow directly through rather than diffusing throughout the soil. If your plant’s pot does not have drainage holes, do not give your plant more than about a third of the pot’s volume of water. If your plant’s pot does have drainage holes, you can add water slowly until the soil is thoroughly moistened and the water flows freely through the pot. If you trim off yellow leaves to improve the plant’s appearance, do not remove more than a third of the plant’s leaves. It may be better to wait until leaves have died and fallen off to remove them.