Solutions: Inspect trees frequently, and remove any infected branches as soon as possible. Branch blight cannot be cured, so the only treatment is to prune the tree and monitor it carefully for signs of the disease. All affected parts of the tree should be removed, since blight can survive over the winter inside the plant’s tissues. Blight can become systemic in the tree, in which case the entire plant should be removed so it does not remain a host for the pathogen and allow it to spread.

Solutions: Some longhorn beetles species are native insects, and they cause little damage. Therefore, these don't warrant control. Other longhorn beetles species are invasive pests that were recently introduced from other areas. These species can cause a great deal of damage to hardwood trees. Apply an insecticide containing imidacloprid as a soil injection or trunk injection following product instructions. This will enter into new grow and kill adults who feed on foliage. This will not help save trees that are already infested with large amounts of larvae, but it will save trees located near an infested tree. Contact an arborist for best control practices regarding infected trees. To properly control longhorn beetles, all host plants in a given area must be treated. Contact a local extension agent or state agency. Tracking the spread of longhorn beetles is a key component of their control.

Solutions: Remove infected tissue. Established trees can survive a crown gall infection, but the galls should be removed to improve the plant's appearance. Use pruning shears to remove the gall, then treat the wound with a pruning sealer. Discard pruned material by putting it in the trash or burning it to avoid infecting other plants. Sterilize the pruning shears after removing the galls. Remove the entire plant. If a small plant is infected with a serious case of crown gall, the best option is to remove the entire plant and burn it. This will prevent bacteria from spreading to other plants. Sterilize the soil. After removing infected tissue, sterilize the soil using heat. Alternatively, plant a gall-resistant plant in the same spot.

Solutions: The easiest (and most obvious) way to address underwatering is to fully hydrate the plant. However, this must be done carefully. A common mistake that many gardeners make is to douse their underwatered plants with water. This can overwhelm the roots of the plant and shock its system, something that can be even more damaging than the lack of water to begin with. Instead, water thoroughly and slowly, taking breaks to let the water slowly saturate through the soil to get to the roots. Use room temperature water, as cold water might be too much of a shock. In the future, shorten the time between waterings. A good rule of thumb is to check the soil around each plant daily. If it’s dry to at least two inches down, it’s time to water. If a container plant is repeatedly drying out very quickly, repotting into a slower-draining container might be a good idea, too.