Solutions: If flower withering is a natural progression due to age, there is nothing that can be done to slow or stop the process. Once hormones within the plant begin the process of senescence, it’s irreversible. For lack of water, immediately water the plant using room temperature rainwater, bottled spring water, or filtered tap water. Water container plants until excess water drains out the bottom; water in-ground plants until the soil is soaked but there isn’t standing water on the surface. In the event of nutritional deficiencies, the best solution is to use a granular or water-soluble liquid fertilizer, and apply it to the soil at about half the recommended dosage. Keep it off the leaves and make sure granular products are watered into the soil well. If the plant is infected with a bacterial or fungal pathogen, there is no course of treatment that cures the diseased plants. The best solution is to remove the infected plants and dispose of the plant material off-site. Do not put in a compost pile.

Solutions: The easiest (and most obvious) way to address underwatering is to fully hydrate the plant. However, this must be done carefully. A common mistake that many gardeners make is to douse their underwatered plants with water. This can overwhelm the roots of the plant and shock its system, something that can be even more damaging than the lack of water to begin with. Instead, water thoroughly and slowly, taking breaks to let the water slowly saturate through the soil to get to the roots. Use room temperature water, as cold water might be too much of a shock. In the future, shorten the time between waterings. A good rule of thumb is to check the soil around each plant daily. If it’s dry to at least two inches down, it’s time to water. If a container plant is repeatedly drying out very quickly, repotting into a slower-draining container might be a good idea, too.

Solutions: Bacterial infections need to be treated quickly to prevent the spread to neighboring, healthy plants, potentially wiping out large sections of your indoor or outdoor garden. In mild cases: Use sterilized (10% bleach solution) pruning shears or scissors to remove any infected plant parts, making sure to dispose of them off site. Use a copper-based bactericide to treat the unaffected foliage, as well as the soil, and neighboring plants. Follow the manufacturer’s rate and timing directions found on the product label. In severe cases, where more than half the leaves are affected: Remove all of the infected plants from the garden, disposing of them off site. Treat the soil and neighboring plants using a copper-based bactericide. Follow the manufacturer’s rate and timing directions found on the product label.