Dieback
There are several possible causes for dieback.
Solutions: There are a few things to try when dieback becomes apparent: Fertilize and water the plants - these two steps, along with judicious pruning, can help reduce the stress on the root system and encourage renewed vigor Have an arborist check to see if plant roots are girdling Test soil pH and adjust accordingly Remove and destroy infected twigs and branches
Learn More About the Dieback
Branch blight
Branch blight can cause lignified branches to dry up entirely and die.
Solutions: Inspect trees frequently, and remove any infected branches as soon as possible. Branch blight cannot be cured, so the only treatment is to prune the tree and monitor it carefully for signs of the disease. All affected parts of the tree should be removed, since blight can survive over the winter inside the plant’s tissues. Blight can become systemic in the tree, in which case the entire plant should be removed so it does not remain a host for the pathogen and allow it to spread.
Learn More About the Branch blight
Flower withering
Flowers may dry out due to a sudden change in environment or because the plant has completed its normal flowering period.
Solutions: If flower withering is a natural progression due to age, there is nothing that can be done to slow or stop the process. Once hormones within the plant begin the process of senescence, it’s irreversible. For lack of water, immediately water the plant using room temperature rainwater, bottled spring water, or filtered tap water. Water container plants until excess water drains out the bottom; water in-ground plants until the soil is soaked but there isn’t standing water on the surface. In the event of nutritional deficiencies, the best solution is to use a granular or water-soluble liquid fertilizer, and apply it to the soil at about half the recommended dosage. Keep it off the leaves and make sure granular products are watered into the soil well. If the plant is infected with a bacterial or fungal pathogen, there is no course of treatment that cures the diseased plants. The best solution is to remove the infected plants and dispose of the plant material off-site. Do not put in a compost pile.
Learn More About the Flower withering
Underwatering
Leaves may wilt for a variety of reasons.
Solutions: The easiest (and most obvious) way to address underwatering is to fully hydrate the plant. However, this must be done carefully. A common mistake that many gardeners make is to douse their underwatered plants with water. This can overwhelm the roots of the plant and shock its system, something that can be even more damaging than the lack of water to begin with. Instead, water thoroughly and slowly, taking breaks to let the water slowly saturate through the soil to get to the roots. Use room temperature water, as cold water might be too much of a shock. In the future, shorten the time between waterings. A good rule of thumb is to check the soil around each plant daily. If it’s dry to at least two inches down, it’s time to water. If a container plant is repeatedly drying out very quickly, repotting into a slower-draining container might be a good idea, too.
Learn More About the Underwatering
Brown spot
This infection can cause brown spots or patches to appear on the plant.
Solutions: In minor cases of brown spot, there isn’t any need to treat the disease. However, if much of the foliage is affected and defoliation occurs, the plant will benefit from getting rid of the infection. It is recommended to start by applying organic treatment options, working up to the more potent synthetic, chemical fungicides if necessary. Organic options won’t kill the fungus, but will prevent it from spreading. Dissolve ½ teaspoon of baking soda and one teaspoon of liquid soap in a gallon of water. Using a spray bottle, spray on tops and bottoms of leaves until the mixture drips off. Repeat every two weeks until existing spots stop enlarging and new spots no longer appear. Spray a copper-based fungicidal soap on the leaves, coating the top and bottom leaf surfaces. Reapply as directed on the product label. Copper penetrates the leaf surface and prevents germination of spores so the fungus cannot spread. Apply an all-purpose fungicide to the entire plant, following the label instructions carefully.
Learn More About the Brown spot
Treat and prevent plant diseases.
AI-powered plant doctor helps you diagnose plant problems in seconds.
Download the App